CANWIDE STEEL Safe Job Procedure Doc ID: SJP-04-05
Rev: 1.1
REBAR PROTECTION Date:

SECTION 1 – GENERAL INFORMATION

Prepared by: Phone #:
Site/Project: Site Address:
Prime Contractor/Client:
Prime Contact (Position & Name): Phone #:
On-Site Contact (Position & Name): Phone #:
Scope of Work Performed:
Any additional documents required? (Hot work permits, Lift plan, Toolbox talk, etc.)
If YES, please indicate type and reason:

2. Hazard Identification

Task/activity steps Potential Hazards present Controls (PPE, Equipment, Training, Documents, etc.)
  • Working at, around or above reinforced steel bars (rebar)
  • Impalement could cause serious injury, disabilities, or death
  • Follow SJP
  • Rebar protection devices/solutions.

3. Procedure

PRELIMINARY ACTIVITIES

Where multiple trade activity is scheduled, the priority of work will be reviewed for all trades by the prime contractor, and the appropriate time frame will be scheduled for each trade to complete their scope of work.

Prior to any work commencing supervisors must conduct a hazard assessment of all applicable work areas. Any hazards that are found during the hazard assessment must be addressed prior to any work commencing. Record findings in daily hazard assessment form

PROCEDURES FOR WORKING SAFELY

  1. Supervisors are required to:
    1. Perform a quick visual inspection of the work and identify any protruding rebar where a worker could fall onto, whether from the platform at height or from the same level when moving/handling material,
    2. Ensure rebar identified as posing a risk to any worker are covered. As a general rule, whoever created the hazard must protect the hazard.
  2. Methods to cover the rebar:
    1. Use of wooden troughs (constructed out of standard building materials), or other manufactured covers such as safety rebar channel are acceptable for protecting worker from impalement hazards.
Wooden Trough Rebar Protection
CANWIDE STEEL Safe Job Procedure Doc ID: SJP-04-05
Rev: 1.1
REBAR PROTECTION Date:
    1. Use only reinforced orange mushroom caps (with flat metal plate inside) for vertical rebar.
    2. Non-reinforced orange mushroom caps can only be used on horizontal rebar where there is no risk of impalement to workers. DO NOT use non-reinforced orange mushroom caps (without metal plate inside) on vertical rebar.
    3. Carnie cap and 2x4
    4. Rebar flat caps
Mushroom caps on vertical rebar Horizontal caps Carnie Cap Flat Cap
  1. High zone steel must be flagged with warning or danger tape, so they are visible and easily identified by crane or concrete pump operators.
CANWIDE STEEL SJP Acknowledgment Doc ID: SJP-04-05
Rev: 1.1
Employee Sign-Off Record Date:

Employee Declaration: I confirm that I have read, understood, and will strictly comply with the Safe Job Procedure for Rebar Protection. I agree to utilize required PPE, actively participate in pre-task meetings, and immediately report any unsafe conditions. I acknowledge that failure to follow this SJP may result in disciplinary action.

Employee Name (Print) Signature Date
Arshdeep Singh
Badal dhakal
Bandeep Singh
Beerinder
Bhavkaran Singh
paramjeet Singh
Akashdeep Singh
Emmanuel Ackom
Gaganpreet Singh
Gursewak singh
Harjot Singh
Jasspreet Singh
Kamalpreet singh
Karan
Lovepreet Singh
Lovejeet Singh
Manjot Singh
Manwinder Singh
Manveer Singh
Mehakdeep Singh
Navkaran Singh
Paramveer Singh
Sukhmandeep Singh
Sukhraj Singh
Suraj Parkash Singh
Tinderpal Singh
Vijaypal Singh